What matters should be paid attention to when installing? This is a topic that everyone is more concerned about and discussed. Lithium-ion batteries have the advantages of light weight, small volume, large capacity, and no memory effect, so they have been widely used. Many digital devices use lithium-ion batteries as power sources. The following editor will help you explain the assembly process and installation precautions of lithium-ion battery packs.
1. Lithium-ion battery pack assembly process
Tools/raw materials: positive electrode material, negative electrode material, separator paper
steps/methods
①Pulping:
The
powdered positive and negative active materials are mixed with special
solvents and binders, and the positive and negative positive and
negative materials are made into slurry after stirring at a high speed
evenly.
②Coating film:
The
prepared slurry is uniformly coated on the surface of the metal foil
and dried to form positive and negative pole pieces respectively.
③ Assembly:
What
matters should be paid attention to when installing? This is a topic
that everyone is more concerned about and discussed. Lithium-ion
batteries have the advantages of light weight, small volume, large
capacity, and no memory effect, so they have been widely used. Many
digital devices use lithium-ion batteries
as power sources. The following editor will help you explain the
assembly process and installation precautions of lithium-ion battery
packs.
④Form into:
Use
special battery charging and discharging equipment to conduct charge
and discharge tests on finished batteries, test each battery, and screen
out qualified finished batteries before leaving the factory.
Reminder: The process technology of lithium-ion battery pack
assembly is very strict and complicated. Here is just a brief
introduction! When assembling lithium-ion battery packs, everyone must
strictly follow the standard technology to produce and assemble, and
there should be no slack.
2. Precautions for installation of lithium-ion battery packs
(1)
The connection of all wires must be firm, and the exposed copper wires
are prohibited from touching each other (including cross touching),
which is easy to damage the controller and protect the lithium-ion
battery protection board, and the light does not turn on. Do not
short-circuit between wires during installation.
(2)
The waiting time for the light on during the wiring process will vary
according to the time set by the controller. The capacity of the factory
lithium-ion battery pack is generally half-electric, and the light will
be darker when it is installed for the first time, which is within the
normal range. Lights up normally after 2-3 days of normal charging.
BENZO Energy Technology Co.,Ltd
UFine Technology Co., Ltd
Site: www.bz-battery.com / www.benzoenergy.com
Comments
Post a Comment